

1) I have an HCF modem. Can I use these drivers?

	No, unfortunately these drivers are only for the Conexant HSF (softmodem)
	family, not for the HCF (controllerless) chips. However, we are hoping
	to release HCF drivers for Linux in the future.

2) The modem returns "NO DIALTONE" when I try to dial

	Please check your line cord and country settings (with hsfconfig --country).
	If they are correct and the "NO DIALTONE" problems persist, you
	may try disabling dialtone detection with the "ATX1" command.

3) The modem returns CONNECT messages with bogus connection speeds, like
   "CONNECT 9600" or "CONNECT 115200"

   Use "ATW1" to enable reporting of line speed, error correction protocol
   and DTE speed. See the command set reference manual
   (100498D_RM_HxF_Released.pdf) for details.

4) The modem works, but I can't hear anything when dialing

	Please check the Ln and Mn settings in AT&V. They should be L1 and M1.
	If not, change them with the command: ATL1M1&W

	If you still cannot hear any call progress sounds, and use a
	modem model that does not have its own speaker (such as on a notebook),
	verify your audio mixer settings (using aumix or equivalent utility) to
	ensure that the volume levels are high enough and that the "PhoneIn"
	channel is not muted. 


