This file contains small hints on using gpsk31.

Operation:
---------
F-11: TX
F-12: RX

Ctrl+p: Preferences dialog

Logging:
--------
During operation you may hit Ctrl-w. You will get a window where you can
enter all the information about the current QSO, and also write to xlog.
This Information will also be used for the macros (see below).

In case you are using start- and end time in xlog: start of a QSO is marked by
clicking on the New button and end is marked when you log the QSO.

Fixtexts:
---------
You may create up to 16 fixtexts in the configuration dialog. 
You can use macros in your fix texts:

~t --> Transmit ON
~r --> Receive
~~ --> sends '~'
~c --> sends the others Callsign
~n --> sends the others Name
~q --> sends the others QTH
~s --> sends the RST for the other Station
~mn -> sends your name
~mc -> sends your call
~mq -> sends your QTH

General:
--------
If the Phase Scope is RED, DCD is OFF, and AFC will not work. If the DCD is 
ON (Phase Scope is YELLOW), AFC is working. You can adjust the DCD-Level with
the slider between the Phase Scope and the Spectrum Display.

The Spectrum Display can operate in 2 modes - as spectrum analyzer and as
waterfall display. A right mouse button click into the Spectrum Display area
switches between the two display modes. In waterfall display mode you 
can switch between a colored and monochrome display with the middle mouse
button.

You may want to change the AFC/NET options. Simple klick on the buttons you see,
or use the ALT-Key shortcuts. You can change the frequencies directly using the
2 spin buttons or +/- keys (arrow block). You can also left-click to a station
you see in the spectrum analyzer or waterfall to tune into it.


                                           vy 73's de Luc, LX2GT and Joop, PG4I

Any questions/suggestions/patches to pg4i@amsat.org
